| Recommend Use: Korevon is specially formulated for exterior plastered wall and masonry. It is suitable for new or previously painted masonry surfaces such as brickwork, plaster, cement, rendering and asbestos.
Technical Information
| Finish |
Low sheen finish |
| Color |
According to standard color card. Also available in KCC ColorBank ATM range. |
| Volume Solids |
Approx. 35% (nominal), depends on color. |
| Flash Point |
Non-flammable |
| Specific gravity |
1.18 - 1.31(Depends on Colour). |
| Viscosity |
85 - 105 K.U. |
| Fungus and algae resistant |
Excellent. |
| Alkali resistant |
Good. |
| Water resistant |
Good. |
| Scrub resistant |
Good. |
| Shelf life |
12 months. |
Application Details
| Application Methods |
Roller, brush or Spray gun. |
| Mixing ratio (by volume) |
The paint is ready for use after thorough stirring. For sealing new or bare surface thin up to 10% of clean water. |
| Thinner / cleaner |
Clean water. |
| Dry to touch |
15-30 minutes, depending on ambient temperature. |
| Hard dry |
30-60 minutes, depending on ambient temperature. |
| Dry to recoat |
2 hours. |
| Theoretical spreading rate |
10 m2 / liter. |
| Practical spreading rate (depend surface porosity) |
8 m2 / liter(20% loss factor). |
| Wet film thickness |
100 microns. |
| Dry film thickness |
35 microns. |
Surface Preparation
New and bare surface
New plastered surfaces must be allowed to dry thoroughly at least 28 days or less than 12% moisture content as measured with a moisture meter. All surfaces to be painted must be sound, dry, clean and free of oil, grease, dirt, mildew, form release agents, curing compounds and other foreign substrates.
Previously painted surface
All loose or defective paint or powdery residues shall be removed by brushing and scrapping using a stiff fiber brush or high pressured water jet. Any area affected by mould, algae, lichen, moss and fungus shall be treated with KCC fungicidal solution. Make good any minor surface imperfection with suitable exterior grade putty or sealant. Ensure surface is dry, clean, free from dirt, grease or wax before application of any paint. Porous surface with high absorption should first primed with Koresil 400 or Koresil 401 sealers.
Typical Painting System
| Surface condition |
Sealer (1 coat) |
Finishing (2 coats) |
| New and bare surface |
Koresil 400 or Koresil 401 |
Korevon |
| Previously painted surface |
Koresil 400 or Koresil 401 |
Korevon |
Storage and Packaging
| Storage |
The product must be kept in a cool and well-ventilated place protected from direct sunlight. Container must be kept tightly close. |
| Handling |
Handle with care. Stir well before use. |
| Pack Size |
5 liters & 20 liters. |
Safety Precaution
Avoid contact with skin and eyes. Keep container closed when no in use. Provide good ventilation during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Do not empty into drains or water courses, Keep out of Reach of Children. | 
